georig220 600xGEORIG 220 is designed for CPT/CPTU and static penetration and has a pushing capacity of 200 kN. With optional equipment it is also possible to perform dynamic sounding/SPT, vane testing and sampling.


The feed force is adjustable from 0 up to 200 kN. Equipped with an overload control unit it is also possible to pre-set a maximum resistance when the hydraulics should be shut off, this is collected from the point resistance in the probe.

The main cylinders who are used for pushing and pulling is controlled by two valves which one is adjustable for pre-setting to appropriate speed (eg. 20mm/sec for CPT) and the other is "full" speed.






back2IMG 4163xGeorig 220 carries all equipment on board. Rod quiver, anchor rack and storage box are standard equipment so you have everything in one place and don't need to carry equipment separately.


Depending on soil conditions reaction force will appear and the rig needs to be anchored. This can be done with up to four anchors.







Technical specification:

Engine:  25 kW Diesel, 3 cylinder          Weight:    2 000 - 2 500 kg depending on equipment 
Stroke:   1500 mm    Length:  2650 mm 
Push force, max:      200 kN    Width:  1660 mm 
Pull force, max: 200 kN    Height:  1790 mm 



GEORIG 220 Gallery

Ingenjörsfirman Geotech AB
Datavägen 53
SE-436 32 Askim
Phone: +46 31 28 99 20
CPTU - Piezocone - Piezometer - Electrical Vane Tester - Groundwater monitoring - Geotechnical drilling rigs - Percussion sounding - Seismic CPT - Piston sampler - SPT - Weight sounding - Soil/rock sounding - Auger - Penetrometer - Electric conductivity - Pore water pressure - Rods